Board Management

Single Management

1. Open the device card → Boards tab
2. Click Config ↗ 3. Select Enabled or Disabled for each board
3. Click Apply ## Group Management
4. Select devices → Boards config 2. Specify the action for each board slot
5. Click Apply ### Available Actions

Rule Builder

For conditional actions Enable if and Disable if, a Rule Builder is available — a rule constructor with conditions:

• Status — by board status (Mining, Failure, Stopped, etc.)
• Temperature — by chip temperature

Conditions are combined with And / Or logic.

Example

Disable board 1 where status = Failure AND temperature > 85°C:

• Action: Disable if - Condition 1: Status = Failure
• Condition 2: Temperature > 85°C
• Logic: And

Devices without HashCore Firmware are skipped during group operations and displayed in the Failed section with the note "Not supported".